A dedicated resting point for your headset when not in active use. This STL file is recommended for FDM Printers!3D Printing Time : Monocolor - 05 Hours, 39 Minutes* (may vary according to your printer model) Multiparts - 08 Hours, 58 Minutes* (may vary according to your printer model)Approximately Height: 021 cm *Note: Printing time based on a Bambu P1S printer, according to our tests.ATTENTION: “Multipart” files requires super glue. You can insert a piece of filament into the indicated areas to achieve the same finish we used. It is important to insert the filament, cut it, and glue it in place. 3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE) Line Width/ Nozzle: 0.4 mmFirst Layer Line Width: 0.48 mm / 120%Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab)Recommended Initial Layer Height: 0.20 mmRecommended Layer Height: 0.20 mmRecommended Perimeters/ Walls: 3.Recommended Infill (%): 5% (Gyroid)Needs Support: Yes (Paint tree slim support only on “Center” on multipart files)Build Plate Adhesion: No.The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.Happy Printing!